We have made a brief introduction about how to erect Ringlock Scaffolding before. Today, we will write a passage about the guideline before disassembling Ringlock Scaffolding.

Ringlock Scaffolding dismantling process is not different from most other types of the scaffold. Generally, the dismantling procedure is the reverse of the erection procedure. This means the last component installed is the first to be removed. The following points are not to be considered as unique to Ringlock Scaffolding but will provide you with a guide for general Scaffolding safe practices.

1. The Supervisor should have a meeting with all the dismantling staff of scaffolders to develop a safe plan of work which identifies, controls and/or removes all identifiable hazards prior to starting the dismantling. This should have formed part of the Risk Assessment.

2. As Ringlock Scaffolding is being dismantled, control the traffic of site personnel and the general public in the area immediately below and around the scaffold. If necessary barricade the area.

3. Ensure that all scaffolders have the correct personal protective equipment (PPE).

4. Handle all components carefully so that they will not get damaged. The safety of those dismantling the scaffold and the public should take top priority during dismantling.

5. Before starting the dismantling procedures, inspect the entire area where the scaffold is to be dismantled. Replace any components that have been removed. Pay very close attention to bracing and ties.

6. Do not remove a scaffold tie until the scaffold components above the tie have been disassembled and lowered to the ground.

7. Use temporary work platforms or loading platforms at each level.

8. All scaffolders should be wearing safety harnesses and other appropriate PPE. Where necessary, harnesses should be attached to the scaffold at appropriate points (refer to Safety Harness Attachment Guidelines)

9. Use ropes and slings to raise scaffold parts. Do not throw components up and down.

10. Inspect all components to ensure that each one is suitable and fit for purpose the next time it is used. Identify all damaged components by tagging or marking them conspicuously.

11. These damaged components should be kept separated and segregated from all the other components.