And disc ringlock scaffolding used more, so when using need to understand and disc scaffolding structures, what are the rules and approaches, which can make construction to avoid some mistakes, improve the efficiency of the building, reduce the cost.

Need faster and more safe to build disc scaffolding you need according to the right way to set up, it has special regulations. In structures, where need to install the base, for example, there is the need to install the outer nylon net to protect, all of these are in the provisions of the building.

And disc scaffolding structures, methods and the following requirements, in enter indoor wall masonry, wall plaster, decoration, the stud spacing of 1.5 meters, step distance of 1.8 meters, the operational layer spread 50 thick stamping steel scaffolding. The operational layer disc scaffolding set-up not less than 1.2 meters platform over the border guard and a 180 high quality foot and medial hung dense mesh net. Using rod, poling horizontal distance, vertical distance of 1.50 meters, 300 Mimi poling is apart from the wall.

Adjacent to the joint position of stud should stagger, decorate in different interval, sync or different across two adjacent joint in horizontal direction of stagger distance should not be less than 500 meters. Every master node must set a lateral horizontal pole, and USES the right-angle fastener tightening in the upper longitudinal bar, end the extended length of not less than 10 cm.

The pole axis deviation from the master node distance should not be greater than 150 c m, in double bent, side against the wall of overhanging length should not be greater than 50 c m. These build in and disc scaffolding method will have a very detailed instructions and regulations, only need according to the steps to operate, main structures, need to check in time to prevent the fault occur.