The so-called ringlock scaffolding is refers to the socket type button scaffold, matters needing attention are as follows:
1, buckle with socket type ringlock type steel tube scaffold erection of double-row scaffold, the erection height should not be greater than 24 m.

Can choose according to the requirement frame body geometry size, the adjacent level interval appropriate chooses 2 m, poling longitudinal spacing should be 1.5 m or 1.8 m, and should not be greater than 2. 1 m, poling horizontal spacing should be 0.9 m or 0.9 m.
2, scaffolding first poling appropriate USES different length of poling staggered, wrong to open bar vertical distance should be not less than 500 mm.

3, along the plane of the lateral longitudinal every 5 across each layer should be set a vertical or diagonal should be set up between every 5 across fastener steel pipe bracing, end span of horizontal vertical diagonal should be set on each floor.
4, even the wall is a must adopt rigid bar may withstand the compressive load, even the wall with the scaffold facade and the wall should be kept vertical, the same layer of the wall should be in the same plane, should not be greater than 3 across horizontal spacing, distance from the lateral aspect of the main structure should not be greater than 300 mm.

5, homework layer scaffold board frame body lateral should set foot, guardrails, and should be facade hung on the outside of the scaffold dense mesh net; Protective railings on the appropriate settings in the operating layer height is l000mm, protective railings in appropriate setting off the homework layer height is 500 mm.