Scaffolding fittings should be paid attention to during construction don't match the door frame and accessories shall not be mixed in the same scaffold. The door frame when installation should be from one end to the other end, and can change the direction of the erection, step by step shall not relative. After take the step frame, shall check and adjust the level and vertical degree. Scaffolding around the building should be continuous, simultaneous build-up, forms a closed scaffolding square tube structure around the building; If not closed, the scaffold should add the wall on both ends.

When scaffold height more than 20 m, should every step 4 on the outside of scaffolding set a horizontal reinforcing rod, and appropriate there is even a wall in a horizontal layer Settings; Set the longitudinal reinforcing Scaffolding tube should be continuous, and form a level;

In scaffolding step at the bottom of the door frame of mouth Scaffolding tube, bottom should seal the door frame of internal and external sides should set tong long sweeping Scaffolding tube; Horizontal reinforcing rod fasteners should be adopted for the stud pin down with the door frame. Bowl scaffold fittings surface treatment: zinc immersion (galvanizing) castor, plating (cold galvanizing) : also known as the land wheel, can be installed at the bottom of the mobile scaffolding, movable scaffolding.

Can be used as mechanical and electrical installation. Paint finish. Equipment maintenance. The advertising activities of the working platform. Castor is 6 inches belt brake is easy to use. Mobile flexible. Safe and reliable advantages.

Scaffold accessories development is very slow, imperfect from start to the final step by step closer to perfect, has experienced a long process. Scaffolding tube ends flattening part with pin holes and assembled with lock pin lock on the door frame stud.